Table 51: CTP Bundle Custom Clocking Settings in the CTP Menu (continued)
Your ActionFunctionField
Select one (the values that appear
depend on whether the bundle is
configured as the DCE or as the DTE):
•
OFF—No clock is used.
•
ST (ext clk)—Send timing clock. The
interface clock signal from the DCE to
the DTE (CTP device).
•
DDS (synth)—Direct digital synthesizer
clock
•
TT (ext clk)—Transmit timing clock.
The interface clock signal from the
DTE to the DCE (CTP device).
•
RT (ext clk)—Receive timing clock.
Interface clock signal from the DCE to
the DTE (CTP device).
•
DIV (synth)—Divider clock generator.
Specifies the clock used for Receive
Frequency on the network bound
interface.
RF (net bound fifo) clk sel
Select one (the values that appear
depend on whether the bundle is
configured as the DCE or as the DTE):
•
OFF—No clock is used.
•
ST (ext clk)—Send timing clock. The
interface clock signal from the DCE to
the DTE (CTP device).
•
DDS (synth)—Direct digital synthesizer
clock
•
TT (ext clk)—Transmit timing clock.
The interface clock signal from the
DTE to the DCE (CTP device).
•
RT (ext clk)—Receive timing clock.
Interface clock signal from the DCE to
the DTE (CTP device).
•
DIV (synth)—Divider clock generator.
Specifies the clock used for the Receive
Data path on the network bound serial
communications controller (SCC).
RX (net bound scc) clk sel
Select one:
•
OFF—No clock is used.
•
DDS (synth)—Direct digital synthesizer
clock
•
TT (ext clk)—Transmit timing clock.
The interface clock signal from the
DTE to the DCE (CTP device).
•
DIV (synth)—Divider clock generator.
Specifies the clock used for Receive
Timing on the interface bound interface.
This parameter appears only if you have
configured the bundle as the DCE.
RT (i/f bound i/f) clk sel
Copyright © 2018, Juniper Networks, Inc.114
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
To Next Page
Loading...
