Juniper CTP Series User Manual

Table 28: CTP Bundle T1/E1 Port Parameter Settings in the CTP Menu (continued)
Your ActionFunctionField
Select one:
•
RJ48
•
COAX
For E1 interfaces, configure the
termination to work with either coaxial
or RJ-48.
Option (for E1)
The following clock synthesizer settings
are set by the software, and you cannot
change them:
•
For T1, the clock synthesizer is set to
1544 KHz.
•
For E1 the clock synthesizer is set to
2048 KHz.
Clock synthesizer
For T1, select a number from 1 through
24.
For E1, select a number from 1 through
31.
Specifies the number of fractional T1 or
E1 channels to transport.
Fractional channels
Select one:
•
y (yes)—Frame Transport—Framing
bit is transported along with data,
which results in data alignment with
the frame.
•
n (no)t—Framing bit is not
transported.
For fractional T1, enables or disables
fractional frame transport.
Fractional Frame Transport
Select one:
•
n (no)—Common channel signaling
(CSS) is used. The common channel
carries data messages that convey
signaling for the circuits between two
devices.
•
y (yes)—Channel associated signaling
(CAS) is used. Each traffic channel has
a dedicated signaling channel
(channel 16).
Specifies the signaling method used for
fractional E1.
CAS support
71Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English