enabled
2 total interfaces, 2 enabled, 0 disabled
2 enabled interfaces performing graceful restart
1 learned groups
MLD Statistics:
Rcvd: 1 total, 0 checksum errors, 0 unknown types, 0 discards
0 queries, 1 reports, 0 leaves
Sent: 2 total
• See show ipv6 mld.
show ipv6 mld groups
• Use to display statically joined and directly connected groups learned through MLD.
• Field descriptions
• Grp Address—Address of the multicast group
• Interface—Interface that discovered the multicast group
• oif-map—Name of the OIF map and the mapped OIF interface, if a group or source
has been mapped to an OIF
• State—MLD version of the group
• Reporter—Link-local address of the host reporting the multicast group
• ExpTim—Remaining time, in seconds, at which the router stops polling for more
members of this group
• oldHTo—Remaining time at which the router stops polling for more MLDv1 members
of a group. If this value is 0, the interface has received no MLDv1 reports for the group.
• Included Sources—Sources included in the multicast group
• Excluded Sources—Sources excluded from the multicast group
• Counts—Number of source-group mappings by version and state
• Example 1—Without OIF mapping
host1:boston# show ipv6 mld groups
Grp Address Interface State Reporter ExpTim oldHTo
------------------- ---------------------- -------- --------------- ------ ------
ff0e::1 ATM2/0.15 Version2 fe80::90:1a02:1 54 0
640:91d
ff0e::4:1 ATM2/0.15 Version2 fe80::90:1a02:1 54 0
640:91d
Included Sources:
51::1 54
51::2 54
Counts: 2 version-2, 0 version-1, 0 check state, 0 disabled
(2 total)
0 excluded
Source-groups: 2 included, 0 excluded
• Example 2—With OIF mapping
Copyright © 2010, Juniper Networks, Inc.192
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...
Need help?
General
