NOTE: The same AC power supply is used in both the SRX3400 and SRX3600 Services Gateways.
However, this power supply is not interchangeable with that used in the SRX1400 Services Gateway.
The SRX1400 Services Gateway power supply will fit into the SRX3600 Services Gateway, but will
not work properly. You can identify the SRX1400 Services Gateway power supply by the plastic
air filter assembly installed over the cooling air inlet as shown in Figure 51 on page 133.
Figure 51: Identifying Power Supply Types
g036110
Air filter
SRX3400 and SRX3600 DC Power Supply
SRX3400 and SRX3600 AC Power Supply
SRX1400 DC Power Supply
SRX1400 AC Power Supply
To install an AC power supply:
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the
SRX3600 Services Gateway.
2. Orient the power supply so that the locking lever is on the right, as shown in Figure 52 on page 134.
133
To Next Page
Loading...
Need help?
General
