ChargingTheBatteryPack
The battery pacl< has not been charged at the t\_ctory. Before using it, be sure to charge it with the A(
Charger Station.
ATTACH DETACH
Battery pack BN-V607U
To AC outlet
Power cord
Power cord
AC Charger Station
AA-V60EG
DC OUT jack
Charger indicator
Power lamp
SUPPLY POWER TO CHARGER
Plug the AC ( harger Station's Dower cord in to
an A( outlet. The power lamp comes on.
ATTACH BATTERY
Attach while making sure the _ marks are
facing down and aligned with the correspond-
ing marl<s on the AC Charger Station.
The ( harger Indicator begins blinl<ing to
indicate chalging has started.
CONFIRM STATUS
When the charger indicator stops blinldng but
stays lit, charging is finished.
DETACH BATTERY
Slide the battery in the direction of the arrow
and lift off.
Remember to unplug the AC Chalger
Station's Dower cord from an AC outlet.
Battery Approximate charging time
BN-V607U 90 rain.
BN-V6t5U
180 rnin.
(optional)
NOTES:
• Ify,_u connect tile camcord_r'_ DC cord to tile AC
Charger Statiorl during battery charging, power is
supplied to the camcorder and char_ing stops
l_ / pg. I0).
• When using tile AL Charger Station, be sure t_
use the supplied power cord only.
• When charging the Battery Pack lbr the first time
or after a long storage period, the Charger
Indicator may not liy, ht. In this case, remove the
Baltery Pack from the AC Charger Station, then try
charging again.
• Since the AC Charger Station processes electricity
interrlally, it becomes warm during use. Be stlre to
use it only in well-verltilated areas.
• If the battery operation time remains extremely
short even after havin_ been lully charged, the
battery is worn out and needs to be replaced.
Please i)urchase a new one.
INFORMATION:
The AC Charger Station (provided) enables you
to charge net only one battery pack but also
one battery pack installed in the camcorder
(_T_ pg. 53).
To Next Page
Loading...
