TNC Commands
You have a choice of whether to have your KAM’98 prepared to deal with a
small set of (22) NEWUSER commands (which is the default setting) or with the
full set of over 130 commands it is capable of carrying out.
+
Note: To switch to the full command set of the KAM’98, get in COMMAND
Mode (<Ctrl+C> or press F9 in Pacterm 2.0) and give the command INTFACE
TERMINAL. To switch back, give the command INTFACE NEWUSER.
NEWUSER Commands
The following diagram shows all the NEWUSER commands and summarizes
each command.
Packet Operations Getting Started
KAM’98 v 8.3 101 User’s Guide
To Next Page
Loading...