Starting Pacterm
To start Pacterm, once you have connected your TNC to your computer:
1. Use DOS to go to the drive and directory where you have installed Pacterm.
For example, if you copied Pacterm to “C:\COMM” by using the Install pro
-
gram, type “C:\COMM”, then press the ENTER key and you will see the
prompt “C:\COMM”.
+
Hint: If you are using Microsoft Windows 3.1 or above, you can use the Pro
-
gram Manager, File Manager, or click on the DOS icon in the Main Window to
run Pacterm as a DOS program from within Windows. But do not run any other
program at the same time as Pacterm, or you may lose data.
2. Type PACTERM and press the ENTER key.
+ Hint: The drive and directory from which you call Pacterm does not need to be
the same as that where the program is stored. From Pacterm’s point of view, the
current drive and directory (e.g., used for SAVING the Holding Buffer) is the
drive and directory from which you start Pacterm. For example, suppose the
program PACTERM.COM is in C:\COMM (i.e., drive C, directory COMM)
and you are on directory SAVEBUFF on a disk in drive A
(A:\SAVEBUFF). In this case, the DOS command C:\COMM\PACTERM will
start Pacterm and the current drive and directory will be A:\SAVEBUFF.
3. The first screen you will see is the MAIN Menu screen. Use the SETUP
functions as needed, then you are ready to go on to the Terminal Screen.
4. Press the BACKSPACE key on the MAIN Menu to go to the Terminal
Screen and begin using Pacterm for communicating with your TNC.
5. If Pacterm cannot establish communication, it will assist by presenting a
“Pacterm cannot communicate” screen (shown above), which describes steps
you can take to establish communication. You may just need to turn on your
TNC and/or press the F7 key to tell Pacterm to try communicating through
COM1, instead of the default serial port, COM2. As soon as Pacterm can
communicate, it gives you the MAIN Menu, so you can try again.
Starting Pacterm Pacterm v 2.0
KAM’98 v 8.3 75 User’s Guide
To Next Page
Loading...