ASCII Directives
While you are in ASCII mode, several directives are activated; they function as
indicated:
<Ctrl+C>E Return to receive mode when transmit
buffer is empty
<Ctrl+C>I Invert received MARK/SPACE signals and
invert transmitted MARK/SPACE
if using AFSK (SSB)
<Ctrl+C>R Return to receive mode immediately.
(If the transmit buffer isn’t empty, the
remaining data will stay in the buffer.)
<Ctrl+C>T Enter transmit mode
<Ctrl+C>X Exit ASCII mode and return to
Command mode (packet)
<Ctrl+C>n Change operating speed
n speed (baud)
145
250
357
475
5 100
6 110
7 150
8 200
9 300
0 ASCBAUD
CW Operation
At the command prompt, type CW and press return to place the KAM’98 in the
CW mode of operation. The KAM’98 will enter the CW mode, ready to receive
Morse code at the speed set in the CWSPEED command. The KAM’98 will auto
-
matically adjust its receive speed to match the incoming signal within approxi
-
mately +/-20 words per minute.
CW Operation Non-Packet Modes of Communication
KAM’98 v 8.3 123 User’s Guide
To Next Page
Loading...