RESET - Causes the TNC to perform a soft reset.
STATUS - Displays the status of the current stream and all connected streams.
TXDELAY - Sets the time delay between Push-to-Talk and the beginning of data.
UNPROTO - Sets the destination field and digipeaters used for any unconnected
data packets transmitted.
VERSION - Displays the current version number of the EPROM (firmware) in
your TNC.
Using NEWUSER Packet Commands
A brief look at the use of selected NEWUSER commands will give you the fa-
miliarity you need to continue on your own using KAM’98 commands.
Check Your KAM’98’s Version Number and ID
To check your KAM’98’s version number and ID all you need to do is ask to see
the current setting of the command called VERSION:
Step 1. Go to COMMAND mode (if you are not already there).
Step 2. Type “VERSION” (or the short form, “V”) and press the
ENTER key to enter the command.
Step 3. The KAM’98 will send it’s version number and other ID
information for display on your monitor.
Get Help
To see a one-line explanation of any command that is currently available:
Step 1. Go to COMMAND mode (if you are not already there).
Step 2. Type “HELP,” (or “?”) followed by one or more spaces
and the name of the command for which you want help.
Getting Started Packet Operations
User’s Guide 104 KAM’98 v 8.3
To Next Page
Loading...