two parts are touching from front to back,
and hold the parts loosely together,
•
while holding the DB-9 connector in place
in the shell, insert the two long,
half-threaded screws (with their washers)
into the holes on either side of the
back-plane of the DB-9 connector, until the
washers (and screw heads) contact the
shoulder on the shell and fit in the
semi-circular gap in the shell designed to
hold the screw in place,
• fasten the two sides of the shell together us-
ing the screws and nuts selected above.
This completes the construction of your transceiver cable assembly. Now it needs
to be connected.
Connecting Your Transceiver Cable Assembly
Now you are ready to use this cable assembly to finish assembling your
multi-mode digital radio station (which may use an HF, HF/VHF or VHF trans-
ceiver.
Step 1. Check to be sure all the parts of your completed cable
assembly are properly fastened and ready for connection
to your transceiver and your KAM’98.
Step 2. Turn OFF all power.
Step 3. Plug the male DB-9 connector on the cable into the
female DB-9 connector on the KAM’98’s “Radio” port,
Step 4. Secure the male DB-9 connector on the cable to the
female DB-9 connector on the KAM’98’s “Radio” port,
by screwing the two long, half-threaded screws into the
threaded nuts on each side of the KAM’98’s “Radio”
port,
Connect Your KAM’98 to Your Transceiver Installing Your KAM’98
KAM’98 v 8.3 63 User’s Guide
To Next Page
Loading...