3. Type COPY A (or B):PACTERM.COM and press the ENTER key. This
will copy PACTERM.COM to your current directory (shown at your DOS
prompt).
Guided Installation
Another way to install Pacterm on your hard drive is to use the Kantronics Pro
-
gram and Information disk to guide you through the steps, as follows:
1. Put the Kantronics Program and Information disk (or a backup) in a floppy
drive (e.g., A or B) and, if you are not already there, change to the floppy
drive where you put this disk (e.g., type and enter A: or B: as appropriate),
2. Type TNC and press the ENTER key, to start the TNC program, and use the
on-screen menus to select PACTERM, then INSTALL PACTERM, and
then follow the on-screen instructions,
3. Type and enter the drive to which you want Pacterm copied (e.g., C), which
can be any drive (except the floppy drive with the Kantronics Program and
Information disk it it) that has the space for it,
4. Next, type and enter the directory or subdirectory (e.g., \PACTERM)to
which you want Pacterm (the program) copied. If you specify a directory or
subdirectory that does not already exist, the installation program will create it
and then copy PACTERM.COM there.
5. Check the on-screen confirmation of the installation and EXIT to DOS.
Saving Pacterm on a Floppy Disk
You may use the Pacterm program on the backup copy of the “Kantronics
Program and Information: Disk 1" disk or on another floppy disk (a disk to which
you have copied the file named “PACTERM.COM”). In this case, you do not
need to do anything special to install it. Just follow the “Starting Pacterm”
instructions given below.
Installing Pacterm Pacterm v 2.0
KAM’98 v 8.3 73 User’s Guide
To Next Page
Loading...