<Ctrl+C>R Return to receive mode immediately.
(If the transmit buffer isn’t empty,
remaining data will stay in the buffer.)
<Ctrl+C>T Enter transmit mode
<Ctrl+C>X Exit RTTY mode and return to
Command mode (packet)
<Ctrl+C>n Change operating speed
n speed (baud)
145
250
357
475
5 100
6 110
7 150
8 200
9 300
0 ASCBAUD
MARS Feature
When you set CODE RTTY MARS in your KAM’98, several special functions
are enabled for RTTY operation.
A. Typing <Ctrl+G> on the keyboard automatically sends
(FIGS)JJJJJSSSSS(LTRS) over the radio. This is an attention signal.
B. When you first enter the transmit mode (with <Ctrl+C>T),
the KAM’98 will transmit 5 SPACES followed by <CR><CR><LF> before
any other data.
C. Typing <Ctrl+P> will signify a page break in a long message by
transmitting <CR><CR><LF><LF><LF><LF> .
D. Typing <Ctrl+Z> will transmit the end-of-message signal
<CR><CR><LF><LF><LF><LF>NNNN and 12 LTRS shift characters.
To fully comply with the MARS RTTY guidelines published in FM 11-490-7,
you will need to set CRADD ON, LFADD ON, AUTOCR 69, AUTOLF OFF,
CRSUP OFF, and LFSUP OFF.
Non-Packet Modes of Communication RTTY Operation
User’s Guide 140 KAM’98 v 8.3
To Next Page
Loading...