List of NEWUSER Commands
The following is an alphabetical listing of the 22 NEWUSER commands, with a
brief description of each command.
BKONDEL - When ON echoes a backspace-space-backspace sequence to the
screen each time you press the DELETE key to erase errors from your screen.
When OFF, echoes a \ for each press of the DELETE key.
CONNECT - Used to establish a packet connection with another station.
CONVERS - Places the TNC in CONVERS mode.
DISCONNE - Used to disconnect from a station you have been talking to.
DAYTIME - Used to read or set the clock in the TNC.
DELETE - Determines the character received from the computer which will
cause the previous character to be removed from the transmit buffer.
DISPLAY - Causes a screen display of all TNC parameters.
DWAIT - Time delay imposed to insure that digipeaters have priority access to
the radio frequency.
ECHO - When ON characters you type on the keyboard will be echoed back to
your terminal. When OFF characters you type will not be echoed.
HELP - Displays a complete list of all available commands on your screen.
INTFACE -
Selects the NEWUSER command set or the complete (TERMINAL) com
-
mand set. Also used to place the TNC in HOST, BBS, KISS, XKISS, or GPS mode.
K - Switches the TNC into the CONVERS mode (same as CONVERS).
MONITOR - When ON allows the TNC to display monitored packets on the
screen. When OFF, no packets will be displayed unless someone actually con
-
nects to you.
MHEARD - Displays a short list of stations that have recently been heard by
your TNC.
MYCALL - Used to set the callsign of your TNC.
MYPBBS - Sets the callsign used for your personal mailbox in the TNC.
PBBS - Used to set the size (Kbytes) of the Personal BBS in your TNC.
Packet Operations Getting Started
KAM’98 v 8.3 103 User’s Guide
To Next Page
Loading...