Step 3. The KAM’98 will send a short “HELP” message about
the command, for display on your monitor.
View Current Values of Parameters
To see the current value of parameter(s) for any variable (other than the “immedi
-
ate” commands, like CONVERS, that are simple actions, not settings):
Step 1. Go to COMMAND mode, as described above (if you are
not already there).
Step 2. Type the name of the command for which you want to
see current parameter value(s).
Step 3. The KAM’98 will send a message consisting of the
name of the command and the value(s) of it’s parameters
for display on your monitor. For example, if you type
INTFACE, you will see INTFACE NEWUSER if you
are currently in the NEWUSER mode.
+ As explained in the “Command Reference” chapter, the DISPLAY command
can be used to see current values of selected sub-sets of commands.
Change the Value of a Parameter
To change the current value of parameter(s) for any variable (other than the “im
-
mediate” commands, like CONVERS, that are simple actions, not settings):
Step 1. Go to COMMAND mode, as described above (if you are
not already there).
Step 2. Type the name of the command for which you want to
change the current parameter value(s), type one or more
spaces, and enter the new value(s) you want for the pa
-
rameter(s) for the command.
Packet Operations Getting Started
KAM’98 v 8.3 105 User’s Guide
To Next Page
Loading...