Optional Parameter Settings
The following TNC parameters are generally used with their default settings
when running Pacterm, but you may wish to change them. If they have been set
to non-default values, you may wish to change them back.
•
ECHO = ON (default)
•
FLOW = ON (default)
Technical note: Usually, ECHO and FLOW go together, both ON or both
OFF. When using software that supports split screen displays, for example,
set both ECHO and FLOW to OFF.
• XFLOW = ON (default)
Technical note: XFLOW controls whether or not software flow control is
ON. If XFLOW is set to OFF, the following parameters should also be set to
0 (zero): XON, XOFF, START, and STOP.
• FILTER = OFF (default)
• 8BITCONV = ON (default)
+
Hint: Also, the MONITOR parameter may be ON or OFF (default = ON).
You may have Monitor ON while using Pacterm. But to prevent a build-up of
data in an internal buffer in the TNC, you should turn Monitor OFF when exiting
Pacterm and leave the TNC ON. This is because when the TNC’s receive buffer
is full, your station will give a BUSY signal to other stations that try to connect.
Pacterm v 2.0 Coordinating Pacterm and Your TNC
User’s Guide 78 KAM’98 v 8.3
To Next Page
Loading...