To go from the TERMINAL Screen to the MAIN Menu, press the F1 key.
Pacterm Commands: Overview
The following sections provide detailed specifications, helpful hints and technical
information on Pacterm commands. You may refer to this material now or just
start using the program and come back here later if you need more information.
On-Screen Help
The MAIN Menu screen and Terminal Screen have enough information so you
can use them as a guide to the commands available.
From MAIN Menu, BACKSPACE = Go to Terminal Screen
Pressing BACKSPACE to go to the Terminal Screen is the usual first step in a
session, once your COM port and BAUD rate are set up as you need.
MAIN Menu keys (except those used for SETUP or for EXIT to DOS) can also
be used to go to the Terminal Screen.
From Terminal Screen, F1 = Go to MAIN Menu
After you SETUP Pacterm and begin using the Terminal Screen, you will never
need to return to the MAIN Menu, except to change SETUP values
(COM port or BAUD rate) for the current session.
With the following exceptions, all commands that work on the MAIN Menu will
also work from the Terminal Screen:
•
SETUP commands only work on the MAIN Menu.
•
ESC and CTRL+C are interpreted as data in TERMINAL MODE,
so use them as data, not as ways to EXIT to DOS.
+
Hint: To EXIT Pacterm from the Terminal Screen, use F10, or go to the MAIN
Menu and use ESC or CTRL+C from there.
Pacterm Commands: Overview Pacterm v 2.0
KAM’98 v 8.3 81 User’s Guide
To Next Page
Loading...