Kantronics KAM 98 - Additional Parts for Your Multi-Mode Radio Station; Our Assumptions about You

•
2.1 mm power connector
•
a diskette (3.5", DS/HD 1.44MB, formatted for PC (IBM) compatible
computers), which includes PACTERM 2.0, a basic DOS-based PC
terminal program.
+
Note: This is NOT the same program as Kantronics’ Windows
95/98/NT program, Pacterm’98.
•
Warranty registration form (see front of this manual)
•
and, of course, this “User’s Guide” manual
Additional Parts For Your Multi-Mode Radio Station
In addition to your KAM’98 unit, you will need the following parts to set up your
multi-mode digital communication radio station:
• HF and/or VHF transceivers (or a transceiver that can do both)
• Microphone (Mic) or accessory jack connectors for your radios
• A computer (or other RS-232 terminal device)
• A serial modem cable, used to connect the KAM’98 Plus to your
computer
•
A 12 Vdc power supply or power adaptor
Our Assumptions About You
We assume that you are familiar with the following or that you can get help on
these topics if necessary:
•
general familiarity with your radio equipment and it’s intended uses
•
basic use of IBM compatible computers and DOS, including copying
disks and files, working with directories, and identifying and using the
serial (COM) ports on your computer
Introduction Additional Parts For Your Multi-Mode Radio
User’s Guide 18 KAM’98 v 8.3