LM(ine) [ ; ]
Lists all messages in the mailbox which are addressed to you.
LO [+|-]
This command allows you to change the order in which messages are listed.
When set to +, the messages are listed in ascending numerical order (oldest to
newest). When this command is set to “-”, the messages will be listed starting
with the highest message number (newest to oldest). This command will not be
available if the SYSOP has the PBLO command in his TNC set to FIXED.
LT [;]
Causes the PBBS to list all TRAFFIC messages that are currently in the PBBS.
K(ill) n
Deletes message number n from the mailbox. You may only delete TRAFFIC
messages, PRIVATE messages addressed TO or FROM you, or BULLETINS
you sent. The SYSOP may delete any message, including BULLETINS.
KM(ine)
Deletes any messages in the PBBS addressed to you that you have read. If you
have not read a message addressed to you, it will not be deleted.
R(ead) n
Reads a specific message by number. Only PRIVATE messages addressed TO
you, or sent by you, may be read, as well as any BULLETIN or TRAFFIC mes
-
sages. After you read a PRIVATE message addressed to you, the STATUS flag
will automatically be set to Y — it has been read.
Packet Modes of Operation PBBS (Personal Mailbox)
User’s Guide 164 KAM’98 v 8.3
To Next Page
Loading...