LT n text (n = 1-4) (text up to 128 chars)
This command fills the specified location Text (LT) buffer with “text”.
LTP n dest [via call1[,call2,...]] (n=1-4)
+
In multi-port devices, this is a multi-port command.
This command sets the destination callsign and the digipeaters used to transmit
the LT strings.
LTRACK n [LT1] [LT2] [LT3] [LT4] [SYSOP] [TIME]
This command allocates memory for a special tracking buffer used to store LT
messages.
RPRINT text (text up to 128 characters)
This is an immediate command which sends the “text” string from the serial port
of the TNC to the attached device (e.g. GPS unit).
Also, see the GPS setting for the INTFACE command. When this command is set
to GPS, the TNC will enter GPS mode upon power up. Data from the serial port
will be parsed according to the GPSHEAD command, text will be placed into the
LT buffers, and beacons will be transmitted according to the setting of the BLT
commands.
+
Hint: To have the TNC exit GPS Mode, connect a PC or terminal to it and issue
three <Ctrl+C> characters.
Packet Modes of Operation GPS NMEA Interfacing Capability
User’s Guide 188 KAM’98 v 8.3
To Next Page
Loading...