software flow control set this parameter to the character the computer will send
to stop data flow.
See also: start, xflow, xoff, xon
STREAMCA {ON | OFF}
default OFF
When receiving packets addressed only to you (MONITOR OFF and/or MCON
OFF), setting this command ON will enable the display of the callsign of the con
-
nected-to station following the stream identifier of the connection (controlled by
STREAMEV). This is especially useful when operating with multiple connec-
tions allowed.
See also: mcon, monitor, streamev
STREAMEV {ON | OFF}
default OFF
When OFF, the stream indicator is displayed only when a change in streams oc-
curs. When ON, the stream indicator will be displayed with every incoming
packet. This command takes effect only when receiving those packets addressed
to you and MCON is OFF.
See also: mcon, monitor, streamca, streamsw
STREAMSW n (n = $00 - $FF)
default $7C (|)
This command selects the character to be used to signify that a new “stream” or
connection channel is being addressed. To change streams you must type this
streamswitch character followed immediately by the stream designator. The
stream designator is an alphabetic character A through Z, or a through z, limited
by the value of MAXUSERS.
KAM’98 Commands Command Reference
KAM’98 v 8.3 309 User’s Guide
To Next Page