TOR
immediate
This command places the KAM’98 in TOR Standby mode. In this mode, your
KAM’98 will respond to other stations calling you in AMTOR, Pactor, or
G-TOR automatically. In addition, you can monitor or transmit AMTOR FEC.
If INTFACE is set to TERM, when a station links to you the linked message will
indicate which mode is being used.
TRACE {ON | OFF}
default OFF
When ON, frames received in Packet, G-TOR, Pactor, and AMTOR ARQ are
displayed in their entirety, in hexadecimal, including all header information. All
packets which are also eligible for monitoring will be displayed in normal text.
The TRACE function may be toggled on and off when operating AMTOR ARQ,
G-TOR, or Pactor by using the <Ctrl+C><Ctrl+T> directive.
TRANS
immediate
This command causes immediate exit from Command Mode into Transparent
Mode. The current link state is not affected. There are no special editing charac
-
ters, all characters are sent out as received. To get out of Transparent, send the
TNC a modem break if BREAK is ON, or see CMDTIME for a special keyboard
sequence.
See also: break, cmdtime, command
KAM’98 Commands Command Reference
KAM’98 v 8.3 313 User’s Guide
To Next Page