This command allows the TNC to send software flow control (XON and XOFF)
to stop and restart the flow of data from the computer while in the Transparent
Mode. When TXFLOW is OFF, hardware flow control must be used between the
computer and TNC. RTS and CTS must be connected between the TNC and
computer for hardware flow control. When TXFLOW is ON, software flow con
-
trol between the TNC and computer in Transparent Mode will depend on the set
-
ting of XFLOW. XFLOW ON enables software flow control, XFLOW OFF
disables it. When software flow control is enabled, the TNC will send the XON
and XOFF characters to the computer to control data flow.
When set for software flow control, all characters can be sent in Transparent
Mode (including the XON and XOFF characters) by setting TXFLOW ON,
XFLOW ON and TRFLOW OFF. You will not, however, be able to receive the
START and STOP characters, since your terminal program should interpret them
as flow control.
See also: trans, trflow, xflow
UIDIGI ON [+|-] call1[,call2[,call3[,call4]]]
default OFF NONE
Up to 4 call signs can be specified for special digipeater duty. If any of the
UIDIGI calls appears in the to-be-digipeated field of a UI packet, and if
MYCALL does not appear in the source field or any of the has-been-digipeated
fields, the UIDIGI call in the to-be-digipeated field will be replaced by
MYCALL with the H bit set and the packet will be digipeated.
See also: dewait, persist, uidwait, unproto
UIDWAIT [ON|OFF]
default OFF
When UIDWAIT is OFF, “special” digipeat packets (those formed by UIDIGI,
UIFLOOD, or UITRACE only) have their usual channel access; there is no wait
DWAIT or slottime added before transmission once the channel is clear. How
-
Command Reference KAM’98 Commands
User’s Guide 316 KAM’98 v 8.3
To Next Page