XFLOW {ON | OFF}
default ON
When ON software flow control will be implemented according to the settings of
START, STOP, XON, XOFF. For normal software flow control set XFLOW ON,
START $11, STOP $13, XON $11, XOFF $13. The TNC expects the computer or
terminal to respond to the flow control characters XON and XOFF, and the TNC
responds to the START and STOP characters from the computer. When XFLOW
OFF, the TNC will only use and recognize hardware flow control lines (CTS and
RTS) to start or stop data. The RS-232 cable must be wired appropriately. If the
software flow control characters are set to $00, software flow control is not possi
-
ble.
In the Transparent Mode flow control is also determined by the settings of
TRFLOW and TXFLOW.
See also: start, stop, trflow, txflow, xoff, xon
XKCHKSUM {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. The value of
XKCHKSUM controls whether or not the XKISS CHECKSUM mode is active.
See also: xkpolled
XKPOLLED {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. XKPOLLED con
-
trols whether or not the XKISS POLLED mode is active.
See also: xkchksum
KAM’98 Commands Command Reference
KAM’98 v 8.3 321 User’s Guide
To Next Page