KAM’98 v 8.3 361 User’s Guide
A/D converter, 187, 205, 298
additional parts needed, 14
alias for digipeating, 170
alphanumeric pager, 252
AMTOR, HF non-packet mode, 86
analog inputs, 187
APRS, 160, 169
APRS-HSP cable, 160
APRS/GPS digipeating, 169
ASCII chart, 318, 319
ASCII file, SAVE, 83
ASCII, HF non-packet mode, 86
assumptions about you, 63
autobaud, 70
AX.25, 26
AX.25 information packet, 25
AX.25 standard, 20
AX.25L2 ver 1 vs 2, 116
baud rate
defined, 77
select, 77
setting, 204
beacon messages, 208
beginning a session, 93
BIN extension, 82
binary file, saving as, 82
BUDLIST, 114, 210
buffer
Pacterm, Holding Buffer, 80
Pacterm, transmission, 78
Pacterm, type-ahead, 64, 78
TNC, receive, 72
TNC, temporary, 79
TNC, transmit, 87
cable requirements, with Pacterm, 68
cable wiring
RS-232, 283
software settings, 286
to computer (DB-25), 284
CALIBRATE command, 211
calibration, 294-296
calling CQ, 109
callsign, 18, 201, 246
callsign priority
digipeater, 171
checksum, 107
COM port(s)
Pacterm, 68
command format, 198
command listing , 198
Command Mode, 94, 108
go to, using Pacterm, 84
command reference, 197
commands
EXITING Pacterm, 84, 85
giving vs. transmitting data, 94
Pacterm Setup , 76, 77
Pacterm, flow of data, 78
Pacterm, output control, 79- 83
communicate with nearby stations,
102- 103
communication requirements for
Pacterm, 68
communication software, 33
installing, 43
components, 30
computer, 17
configuring the TNC with Pacterm, 71
connect, 110, 216
CONNECT command, 19
connect request, 217
connect to radio, 287-292
connected packet, 23
Connected vs. Unproto, 109
Index
To Next Page