You may find that the steps described in the Quick Start section of that chapter
(see page 71) are all you need or you may want to go through the “Pacterm 2.0”
chapter in more detail.
For details on setting up BAUD rates, see page 76. For information on setting
other KAM’98 parameters, see page 77.
One step that is mentioned only briefly in the “Pacterm 2.0” chapter (see page
77) is that after you set the BAUD rate for the KAM’98, you will be asked to en
-
ter your CALLSIGN, which your KAM’98 will then use until otherwise notified.
So be prepared to enter your CALLSIGN when asked to do so.
IMPORTANT: Now go to the “Pacterm 2.0” chapter, to use the DOS-based ter
-
minal comunication program, Pacterm 2.0, to install and configure software and
KAM’98 parameters and then COME BACK HERE — you still need to connect
your KAM’98 to your transceiver.
NOTE: If you are operating Pacterm’98 (for Windows 95/98/NT), you may
use it to set up the parameter values needed to install the KAM’98.
Installing Your KAM’98 Install Software and Configure Your KAM’98
User’s Guide 50 KAM’98 v 8.3
To Next Page
Loading...