Keba KeContact Series - Page 101

Load management program
101 / 156
Session history table
History type:
Type of the history entry.
Display values:
 Start session
A Charging Session has started.
 Resume session
A charging session has been resumed by the Electric Vehicle.
 End session
A Charging Session has ended.
 Start transaction
A Charging Transaction has started.
 Start system transaction
A new charging transaction has been started by the system because
of an exceptional condition such as Charge Parameter Discovery
without Power Delivery Request while high-level communication.
 End transaction
A Charging Transaction has ended.
 Power exceeded
The Electric Vehicle has drawn more power than assigned in the
Charging Profile or at the Wallbox.
 Renegotiation
A renegotiation has been initiated because the Electric Vehicle has
exceeded the electric current assigned in the Charging Profile.
 No ventilation
The Electric Vehicle has requested ventilation, but the Wallbox
doesn't support ventilation.
Time:
Timestamp of the entry into the session history.
Meter reading:
Meter reading in the transaction history. Might be from different attributes
depending on the type of transaction.
Termination:
Termination reason at the session history. Might be either “Termination
Reasons Session” or “Termination Reason Transaction” depending on
the type of history entry.
Details:
Detailed information contained in the session history.
It will be populated with additional information such as "Contract ID" for
the start of a session or the measured current in case of exceeding the
assigned current.