Keba KeContact Series - Ethernet Wiring

Hardware installation
18 / 156
4.3 Ethernet wiring
For details about installing and connecting the components, please refer to the individual compo-
nent manuals (KeContact P20 Installation manual, Installation manual of your Ethernet switch
and patch panel).
Use the LSA+® terminal block [ETH1] for the Ethernet connection and NOT the RJ45 port.
 In any case the KeContact LAN must be designed as a closed network without direct public access.
Only the KeContact M10 can be connected via the Ethernet port [ETH1] to a public LAN (eg, corporate
network).
 The individual Wallboxes are wired to the patch panel using a Cat6 (or higher quality) patch cable.
 The connection between Ethernet switch and patch panel is made with standard patch cables (2xRJ45).
Color coding:
According to the used wiring standard in the building, the contacts are wired according to TIA-568A/B for
100BaseT:
Pin
-568A
pair
-568B
pair
-568A
color
-568B
color
1 (Tx+)
3
2
white/green
white/orange
2 (Tx−)
3
2
green/white or green
orange/white or orange
3 (Rx+)
2
3
white/orange
white/green
4 (Rx−)
2
3
orange/white or orange
green/white or green
Ethernet port
Pin assignment of LSA+® terminal block [ETH1]
For details please see the “KeContact P20 Installation
manual”.