Load management program
81 / 156
Typical workflow: Enable/ Disable Authorization (Wallbox)
Press the [Configuration] button in the toolbar at the bottom of the screen. The charge
point configuration screen appears.
Click at the button [Wallbox] in the menu bar at the left side of the web page. The Wallbox con-
figuration screen appears.
Select the number of the Wallbox for which authorization will be enabled or disabled.
Check or uncheck the check box "Requires authorization?" as required. Already authorized
charging sessions will not be affected by the change of the authorization policy of the Wallbox.
Press the [Save] button to save the settings.
Return to the home screen by clicking on the [HOME] button .
6.6.2.2 Preconfigured Parameters tab
This screen shows Wallbox parameters reported by the firmware of the Wallbox (read only). A change re-
quires a firmware update or other DIP switch settings.
Wallbox configuration –Preconfigured Parameters
To Next Page
Loading...
