Keba KeContact Series - DIP-Switch Settings

Hardware installation
20 / 156
4.5 DIP-switch settings
Changes in the DIP-switch settings will take effect once the charging station has been restarted!
To do this, press the [Service button] for 1 second or switch the power supply off/on.
DIP-switches
DIP-switches
The DIP-switches are used for the addressing and con-
figuring the charging station and are located under the
connector panel cover.
[DSW1]…configuration (upper DIP-switch)
[DSW2]…addressing (lower DIP-switch)
DIP-switch example
The figure shows for a better explanation, the position
of the DIP-switches for the ON and OFF state.
INPUT/OUTPUT (DSW1) / ONLY FOR STANDARD MODE
Function
DIP-switch
Figure
External enable input [X1]
is used
D1.1
ON=yes
Switch contact output [X2]
is used
D1.2
ON=yes
SmartHome interface via UDP
(details see “UDP Program-
mers Guide”)
D1.3
ON=
enabled