Load management program
35 / 156
Typical workflow: Change password
Try to access a password-protected screen. The KeContact M10 presents the login screen.
Press the button [Change Password]. The “Change Password” screen appears.
Enter the old and the new password and press the button [Change Password].
In case a user forgets the password, an administrator can set a new password.
6.2.3 Standard accounts and passwords
Administrator-Account
Deleting the Administrator-Account is not possible. Change the password for this account immediately at the
first start-up! Do not use very simple or predictable passwords (do not use e.g. “User name: admin / Pass-
word: password”).
User name: admin
Password: Serial number of the M10
Note: The serial number is shown at the login screen
(ID = “Keba_CS”serial number”)
Installation-Account
The installation account has access to all free accessible screens and the installation menu. Only accessible
with a direct physical connection to the Ethernet port [Eth0] of the KeContact M10.
User name: installer
Password: kecontactm10
Configuration-Account (Management-Account)
With the Configuration-Account the system is operated. It has access to all menus except the „Installation
menu“. It is highly recommended to change at least the password for this account.
User name: manager
Password: danube
User-Accounts
Depending on the system it is possible to create user accounts with specific access permissions (details see
chapter “Management menu -> Manage Accounts”).
In your own interest, ensure to store all changed passwords (e.g., employee passwords) at a safe
place. If necessary, this allows the system owner to restore access to the accounts.
To Next Page
Loading...
