Keba KeContact Series - Wallbox Configuration; Configure Wallbox Tab

Load management program
79 / 156
6.6.2 Wallbox configuration
These screens allow the configuration of the Wallbox parameters.
6.6.2.1 Configure Wallbox tab
This screen shows Wallbox parameters that can be changed at the user interface.
Wallbox configuration – Configure Wallbox
Select Wallbox for configuration
Wallbox Number:
The drop down box shows the socket number of all Wallboxes that are
visible at the home screen.
If the user changes the Wallbox number, the screen is shown for the
Wallbox selected by the user. If no Wallbox is passed to the screen,
Wallbox 1 will be selected.
Charge Point information
Charge Point operating
mode:
Describes whether the Charge Point allows Mode 3 charging controlled
by basic signalling, charging controlled by high-level communication or
both.
Authorization enabled?
Shows whether authorization is enabled at the Charge Point.