Load management program
111 / 156
Typical workflow: Manage White list items
Press the [Management] button in the toolbar. The Management screen (Charging Session
Management) appears.
Click at the button [White list] in the menu bar at the left side of the web page. The white list
management screen appears.
Press [New] for entering a new charging token or select a charging token for processing and
press [Change], [Unblock] or [Block].
If "New" has been selected: Enter the new white list entry and press the [Save] button.
Press "New" to enter further white list entries until all new RFIDs and/or PEV-IDs have been en-
tered.
If "Change" has been selected: Change the white list entry and press the [Save] button.
Enter the ID of other charging tokens to be changed and press "Read" until all RFIDs and/or PEV-
IDs have been changed as required.
If "Unblock" is selected, a previously blocked charging token may be used for authorization again.
If "Block" is selected, a charging token can no longer be used for authorization. This doesn't affect
any active charging session that has been authorized using the charging token.
Return to the home screen by clicking on the [HOME] button .
Typical workflow: Teaching vehicle IDs
Whether a vehicle ID acquired by teaching requires approval can be entered at the tab "Authorization" of the
Charge Point configuration screen.
Plug the electric vehicle for which the vehicle ID shall be taught into a non-authorizing Wallbox. A
charging session will be started for the electric vehicle, the vehicle ID will be entered into the in-
ternal white list.
If a vehicle ID acquired by teaching requires approval, press the [Management] button in
the toolbar. The Management screen (Charging Session Management) appears.
Click at the button [White list] in the menu bar. The white list management screen appears.
Select the vehicle ID that has been acquired by teaching and press the button [Accept].
Return to the home screen by clicking on the [HOME] button .
To Next Page
Loading...
