Keba KeContact Series - Page 122

Load management program
122 / 156
Maximum number of archives
Diagnostic archives:
Maximum number of archives containing diagnostics information that
shall be kept at the disk of the KeContact M10.
[default value: 3]
Log file archives:
Maximum number of archives containing log files that shall be kept at the
disk of the KeContact M10.
[default value: 3]
Meter value archives:
Maximum number of archives containing meter values that shall be kept
at the disk of the KeContact M10.
[default value: 3]
Maximum number of versions
Firmware versions:
Maximum number of firmware versions that shall be kept at the disk of
the KeContact M10.
[default value: 3]
Software versions:
Maximum number of software versions that shall be kept at the disk of the
KeContact M10.
[default value: 3]
Typical workflow: Configure automated housekeeping processes
►
Press the [Management] button in the toolbar. The Management screen (Charging Session
Management) appears.
►
Press the menu button [Housekeeping] at the left side of the screen. The housekeeping screen
appears. Review the current state of the disk usage at the KeContact M10.
►
Go to the tab [Housekeeping Parameters] to change the parameters for the housekeeping run.
Change the parameters for the housekeeping run and press “Save”.
►
Return to the home screen by clicking on the [HOME] button .