Keba KeContact Series - Page 140

Load management program
140 / 156
Central System interfaces
Name:
Name of the interface.
Type:
Type of the interface.
Display values:
 System Management
The interface is used for monitoring, managing and configuring the
KeContact server.
 Energy Management
The interface is used to manage the energy offered by the charge
point. An example is a DSO interface using OCPP.
 Energy and System Management
The interface is used for system management and energy manage-
ment.
Status:
Status of the interface.
Display values:
 Online
The KeContact server is communicating with the central system using
the OCPP interface.
 Offline
The host interface is working, but the central system is currently not
reachable.
 Stopped
The interface to the central system has been temporarily deactivated.
Status Time:
Time of the status change.
Buttons
Start:
Press the [Start] button, to start a stopped host interface.
Stop:
Press the [Stop] button, to stop the selected host interface.
Delete:
Press the [Delete] button, to delete the selected host interface.
Any message that has not been sent will be purged. The system might
automatically restart to complete the deletion.
Change:
Press the [Change] button, to change the parameters of the selected
host interface.
Create:
Press the [Create] button, to enter parameters for a new host interface.
Additional information:
OCPP (“Open Charge Point Protocol”) is an interface between the KeContact M10 and an OCPP host. In-
formation about the status, meter values, errors of the M10 and the connected Wallboxes will be provided if
the interface is online.