Load management program
143 / 156
Indicates whether timestamps in messages sent via the Host Interface
shall be in the time of the host (checkbox checked) or in local time at the
KeContact server. The time will only be used in outgoing OCPP messag-
es.
Store message when
stopped?
Indicates whether messages addressed to the host will be stored (check-
box checked) or dropped if the Host Interface is in state “Stopped”.
Message stored if offline for x
minutes
Duration (in minutes) a message addressed to the host will be stored if
the system has gone offline. Only if “Store message when stopped” is
checked.
Authorize message support-
ed?
Indicates whether the central system supports the Authorize message
(checkbox checked).
Press the [Save] button, to store the configuration parameters of the cen-
tral system interface.
If the central interface does not yet exist, it will be created. Creating or
changing of a Central system interface might lead to a restart of the ap-
plication.
Typical workflow: Manage Central System Interfaces
Set metering value collection policy as described in the workflow “Configure Meter Value Collec-
tion”. If encrypted (SSL) communication is used, upload and install the necessary digital certifi-
cates (see workflow “Manage Certificates”).
Press the [Service] button in the toolbar at the bottom of the screen.
Press the menu button [OCPP Interfaces] at the left side of the screen. The OCPP interfaces
overview screen appears.
Press the [Create] button to generate a new interface. The OCPP interface configuration screen
appears.
Enter the parameters of the OCPP interface into the configurations screens. Press the [Save]
button to store the settings.
Return to the home screen by clicking on the [HOME] button .
To Next Page
Loading...
