Keba KeContact Series - Page 57

Load management program
57 / 156
Wallbox available?
Indicates whether the Wallbox is available for charging.
Wallbox reserved?
Indicates whether the Wallbox has been reserved for a particular charg-
ing token.
Details
Fixed cable?
Indicates if the Wallbox has a fixed cable or works with an external cable
that will be plugged into the Wallbox.
Display values:
 Yes / No.
Wallbox plugged?
Indicates whether a cable or a vehicle is plugged into the Wallbox.
Display values:
 Vehicle and Wallbox
 Wallbox only
 No
Wallbox connector locked?
Indicates whether the connector at the side of Wallbox is locked. If there
is a fatal error (Socket Status = fatal), the value of this attribute might not
be accurate, but only indicate the last status reported by the Wallbox.
A Wallbox with a fixed cable will always report locked.
Display values:
 Yes / No.
Wallbox pulsing?
Indicates whether the Wallbox is pulsing.
Display values:
 Yes / No.
Power switch closed?
Indicates whether the power switch inside the Wallbox is closed.
If there is a fatal error (Socket Status=fatal), the value of this attribute
might not be accurate, but only indicate the last status reported by the
Wallbox.
Display values:
 Yes / No.
Nominal voltage:
Voltage (in Volt) used for calculations of power which will be assigned to
the Wallboxes in case of load management. Refers to a single phase
(e.g. 230V in continental Europe).
Valid single line nominal voltage values are:
110, 115, 120 (USA), 127, 208, 220, 230 (Europe), 240
Voltage measured:
Voltage measured at the most recent measurement.
Current offered?
Current offered at the Wallbox (taken from charging profile or the preas-
signed current, whichever applies).
Housing inside temperature?
Shows the temperature inside the Wallbox.
Display values:
 °C / °F.
Energy meter:
Energy meter value in [kWh].