Keba KeContact Series - Page 59

Load management program
59 / 156
Vehicle details
Signalling:
Describes whether the Charging Session is a Mode 3 charging session or
a high-level charging session.
Display values:
 Basic signalling:
Mode 3 charging according to IEC 61851-1 controlled by basic signal-
ling.
 ISO 15118:
Charging session controlled by high-level communication.
Time plugged in:
Point in time when the charging session has started.
Departure time:
[only ISO 15118 relevant]
Planned end of charging as communicated by the electric vehicle during
charge parameter discovery.
Energy consumed:
Energy consumed during the Charging session.
Time started:
Point in time when the charging transaction has started.
Electric vehicles can only charge in charging transactions. A charging
transaction is terminated by a renegotiation, a charging pause, a power
cut or several other exceptions.
Time finished:
Point in time when the charging transaction has ended.
Termination reason:
Code indicating the reason for the termination of a transaction.
Display values:
 Vehicle unplugged:
The EV has initiated the termination by unplugging.
 ISO 15118 command:
The EV has initiated the termination by unplugging.
High-level: The EV has initiated the termination by sending a com-
mand via high-level communication.
 Socket failure:
The charging transaction has been terminated by the Wallbox be-
cause of a socket failure (for example overheating).
 Power control:
The charging transaction has been terminated because the EV has
drawn more than the assigned power.
 Housekeeping:
The EV has unplugged during a power cut, socket unavailability or
down-time of the KeContact M10.
 Charging profile exceeded:
The EV has exceeded its charging profile.
 Derating
The charging transaction has been terminated because the socket
has been derated.