Keba KeContact Series - Page 61

Load management program
61 / 156
Sessions table
Session ID:
Unique identifier of the Charging Session.
Wallbox:
Socket number of the Wallbox.
Start:
Point in time when the charging transaction has started.
End:
Point in time when the charging transaction has ended.
Signalling:
Shows whether the Charging Session was a “Low-level (PWM)” charging
session or a “High-level (ISO 15118)” charging session.
Termination:
Code indicating the reason for the termination of a transaction.
Display values:
 Vehicle unplugged:
The EV has initiated the termination by unplugging.
 ISO 15118 command:
The EV has initiated the termination by unplugging.
High-level: The EV has initiated the termination by sending a com-
mand via high-level communication.
 Socket failure:
The charging transaction has been terminated by the Charge Point
because of a socket failure (for example overheating).
 Power control:
The charging transaction has been terminated because the EV has
drawn more than the assigned power.
 Authorization failure:
Authorization has been denied for the charging session.
 Housekeeping.
The EV has unplugged during a power cut, socket unavailability or
down-time of the KeContact M10.
Energy consumed [kWh]:
Energy consumed during the Charging Session.
Current [A]:
Current according to the last measurement at the Wallbox.
Buttons
Got to Wallbox:
Press the [Go to Wallbox] button to go to the Monitoring menu of the se-
lected Wallbox.
Session history:
Press the [Session history] button to go to the Session History screen.