APPENDIX D
DIRECTIONS
1. Using the front panel program feature, set the primary address of the Model 263 to 8.
2. With the power off, connect the Model 263 to the IEEE-488 interface installed in the IBM
computer.
3. Type in BASIC4 on the computer keyboard to get into the IBM interpretive BASIC language.
4. Enter the lines below using the return key after each line.
5. Run the program and type in the desired command string. For example, to place the in&u-
ment in the current function and 2OOfi range, type in FlR9X and press the return key.
7. The instrument reading string will then appear on the display.
PROGRAM COMMENTS
’ Memory address.
’ Lines 10-50..
’ Routine addresses.
’ PC < > 488 address.
’ 263 address.
’ System controller.
’ Initialize system.
’ Prompt for string.
’ Send command string
’ Make room for data.
’ Get reading from 263.
’ Display reading.
’ Reoeat.
NOTE: For conversion to numeric variable, make the following changes:
D-2
To Next Page
Loading...
Need help?
General
