Kemper 360 - Main Drive Friction Clutches; And 360)

Service
KM00321,000029A 1924FEB101/1
Main Drive Friction Clutches (330,
345 and 360)
General information
The two friction clutches (A) in the main drive protect the
rotary harvesting unit from unnecessary loads. Therefore,
it is required to keep the friction clutches properly
serviced. Torque setting is:
Specification
Main drive friction
clutch—Torque........................................................ 800 N∙m (590 lb.ft.)
Check friction clutches
IMPORTANT: The following steps must be taken
before the rotary harvesting unit is put into
service for the first time, and after every
protracted period it is not in use.
1. Remove cover (B).
2. Tighten nut (C). This will reduce pressure on the
friction plates. Rotate the friction clutch.
3. Loosen nut (C) to the end of thread.
4. Install cover (B).
The friction clutches must be cleaned prior to every
season as the specified torque must not be exceeded.
Torque setting: Position notch (D) towards the inside
and let it engage in the inner recess (E) of housing (F).
A detailed check should be performed by removing,
cleaning and reinstalling spring assembly, friction disks,
friction plates, and hub.
IMPORTANT: A new friction clutch will reach
its full torque only after a breakin period.
For this reason, the rotary harvesting unit
ZX1040657 —UN—12APR07ZX024276 —UN—07MAR01
A—Friction clutches
B—Cover
C—Nut
D—Notch
E—Inner recess
F— Clutch housing
G—Outer recess
must be started cautiously, increasing load
slowly. Full load should be applied only
after the breakin period.
506
040810
PN=101