Kemper 360 - Attaching to KRONE Forage Harvesters

Attaching to a KRONE Forage Harvester
KM00321,0000262 1918FEB101/1
Attaching to KRONE Forage Harvesters
KM1001112 —UN—18FEB10
1. Place the rotary harvesting unit on jackstands (C) and
(D) in front of the forage harvester.
2. Attach the rotary harvesting unit to the feed roll
housing of the forage harvester using suspensions
(A) and (B).
3. While raising the rotary harvesting unit slowly, observe
feed plates (E) and guide plate (F).
IMPORTANT: Feed plates (E) and guide plate
(F) must not touch the feed rolls of
the forage harvester.
4. Lift rear jackstands (C) and secure them.
5. Take out front jackstand (B) and insert dummy plug.
6. Lock rotary harvesting unit.
IMPORTANT: For more information on the
locking mechanism, see Operator’s Manual
of the forage harvester.
KM1001113 —UN—18FEB10
A—Suspension
B—Suspension
C—Rear jackstand
D—Front jackstand
E—Feed plates
F— Guide plate
353
040810
PN=48