Operation of the Rotary Harvesting Unit
KM00113,0000029 1903NOV091/1
Adjusting the Feed Bars (375 up to Construction Year 2009)
ZX024250 —UN—07MAR01
ZX1040578 —UN—12APR07
Feed bar (A) pushes the stalks forward to improve crop
intake. Its height can be altered to suit crop conditions.
Depending on the crop height, central feed/guide bar (B)
should be set as high as possible.
•
Lateral feed bars (A) can be set into two positions (high
or low) by inserting screws (C) in upper or lower hole
of supports (D).
•
Feed/guide bar (B) can be set into different positions by
setting bolt (E) somewhere within slot.
IMPORTANT: Do not raise the feed bars so high that
they collide with each other in the transport
position. After adjustment, always carry out
a test folding to prevent damage.
A—Feed bar
B—Feed/guide bar
C—Fixing screw
D—Support
E—Adjusting bolt
ZX024251 —UN—07MAR01ZX024270 —UN—07MAR01
3027
040810
PN=79
To Next Page
Loading...
