Kemper 360 - Preparation of the Rotary Harvesting Unit; Unpacking; Remove Tensioner Strap; And 360)

Preparation of the Rotary Harvesting Unit
OUKM001,0000027 1901MAR051/1
KM00321,0000255 1927JAN101/1
KM00321,0000256 1927JAN101/1
KM00321,0000257 1927JAN101/1
Unpacking
As soon as packaging material is removed, check the unit
for any damage that might have been incurred during
transport.
Remove Tensioner Strap (Models
345 and 360)
Remove tensioner strap (A).
NOTE: Do NOT discard tensioner strap (A); hand it over
to the customer. It is required whenever the rotary
harvesting unit is hauled separately.
A—Tensioner strap
KM1001082 —UN—22JAN10
Remove Transport Pallet (Model 375 Only)
Remove transport pallet (A).
NOTE: Do NOT discard transport pallet (A); hand it
over to the customer. It is always required to
avoid damage to the machine when transporting
the rotary harvesting unit separately.
A—Transport pallet
KM1001083 —UN—22JAN10
Adapt Feed Plates to Feed Passage
Before attaching the rotary harvesting unit to the forage
harvester, make sure that the feed plates (A) match with
the channel width of the forage harvester.
The feed plates (A) must be adjusted to the channel width
of the relevant forage harvester model.
IMPORTANT: For more information, see Channel
Width Adjustment in the Section for the
relevant forage harvester type.
A—Feed plates
KM1001084 —UN—22JAN10
201
040810
PN=25