Kemper 360 - Accessories; Special Kit for Row Guidance (Steering Assistance); Automatic Height Control Kit; Special Kit for Whole­crop Silage

Accessories
OUCC002,00027FE 1919SEP071/1
KM00321,0000289 1924FEB101/1
OUCC002,00027DF 1918SEP071/1
OUCC002,00027E0 1918SEP071/1
OUCC002,00025C6 1902APR071/1
Special Kit for Row Guidance (Steering
Assistance)
When driving a forage harvester 90 % of the driver’s
attention is focused on steering. Use of the entire machine
capacities is thus only possible with assisted steering.
A special kit is available as an attachment and is
composed of:
•
(2) sensor systems with connecting cables
•
(1) set of hardware for installation on harvesting unit
•
(1) assembly instructions
Automatic Height Control Kit
The automatic height control system consists of two
sensors at both outer dividers that are touching the
ground (following the ground contours) and keep the
rotary harvesting unit parallel to the ground.
The electric impulses of the sensors are converted into
hydraulic oil quantity by the SPFH main control unit.
See forage harvester Operator’s Manual for operation of
automatic height control.
A cylinder is retracted or extended depending on the
oil quantity so that the rotary harvesting unit is always
aligned parallel to the ground.
Special Kit for WholeCrop Silage
To significantly improve capabilities of the harvesting unit
to harvest wholecrop silage, a special kit is available as
an attachment.
On 330 and 345 harvesting unit, the kit is composed of:
•
(2) angles for the outer downcrop augers
•
(2) tips which play the role of dividers
•
(1) assembly instructions
On 360 harvesting unit, the kit is composed of:
•
(2) hooks which play the role of counterknives
•
(2) angles for the outer downcrop augers
•
(2) tips which play the role of dividers
•
(1) assembly instructions
On 375 harvesting unit, the kit is composed of:
•
(4) hooks which play the role of counterknives
•
(2) angles for the outer downcrop augers
•
(2) tips which play the role of dividers
•
(1) assembly instructions
Special Kit for Crops with Very Close or
Wide Row Spacing (345, 360 and 375)
To significantly improve capabilities of the harvesting unit
to harvest such a kind of crop, a special kit is available as
an attachment.
This kit is composed of short dividers which replace the
large dividers.
Special Kit for Quality of Cut
To significantly improve quality of cut, a special kit is
available as an attachment. To prevent plugging in the
feeding channel especially when using one side of the
rotary harvesting unit to harvest along the rows, this kit
allows to adjust the feeding channel according to the
forage harvester channel width.
The kit is composed of:
•
(2) covers for feed drums
•
(2) modified guide plates for enhanced alignment to the
feeding channel
•
(2) adjustable angles
•
(1) assembly instructions
351
040810
PN=84