Kemper 360 - Drive for Down­crop Auger

Service
OUCC002,00027ED 1918SEP074/4
ZX,688RHU010143 1901MAR991/1
Lower feed teeth on feed drums
Deflectors (A) are set at a maximum distance (X) of 4 mm
(0.16 in.) to the tips of feed teeth (B).
ZX012973 —UN—26NOV97
Drive for DownCrop Auger
The belt drive for the downcrop auger is located at the
outer end of the folding sections.
IMPORTANT: Adjust the tension of the belt after the
first 20 hours of operation, then check regularly.
The crossedover Vbelt (A) is guided by a guide roll (B).
Tension on the belt is adjusted by pulling the rear upper
auger bearing upwards.
Adjust belt tension as follows:
IMPORTANT: Do not use guide roll (B) to
tension drive belt (A).
1. Loosen upper auger bearing fixing nuts (C).
2. Turn the adjusting screw (D) clockwise to tension the
drive belt (A).
3. Tighten fixing nuts (C).
ZX012974 —UN—26NOV97
A—Belt
B—Guide roll
C—Fixing nuts
D—Adjusting screw
5012
040810
PN=107