Kemper 360 - Page 36

Attaching to a CLAAS Forage Harvester
KM00321,000026A 1909FEB105/7
Continued on next page KM00321,000026A 1909FEB106/7
5. Put the other end of the u.j. shaft on the rotary
harvesting unit gear box (A).
Rotary harvesting units with rigid attaching frame
only:
Rotary harvesting units with rigid attaching frame must
be lowered so that there is enough room to attach the
u.j. shaft.
•
Disengage rotary harvesting locking device (B).
•
Press function key (C) and lower the rotary
harvesting unit onto a flat surface.
•
Put the u.j. shaft on the rotary harvesting unit gear
box (A).
•
Press function key (D) and raise the rotary harvesting
unit.
•
Engage rotary harvesting locking device (B).
A—Gear box
B—Locking device
C—Function key
D—Function key
KM1001100 —UN—09FEB10KM1001101 —UN—09FEB10KM1001102 —UN—09FEB10
6. Engage locking screw (A) into groove of splined shaft.
Make sure that u.j. shaft can no longer move.
Tighten lock nut (B).
A—Locking screw B—Lock nut
KM1000876 —UN—26MAY09
2511
040810
PN=36