Kemppi X8 - Page 139

X8 MIG WELDER 2.5 Operation
When using MIG, you can adjust the following welding parameters through Settings >
Parameters:
• Wire Feed Speed
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Voltage: adjusts the voltage (arc length).
• Dynamics: -10...+10. Adjusts the short circuit behavior. On the minus side, the arc is softer (less
spatter). On the plus side, the arc is harder (the arc is more stable).
• StartPower: -30...+30. Adjusts the power level for arc ignition.
1-MIG
#
1-MIG is a synergic MIG/MAG welding process: when you adjust the wire feed speed, the power
source adjusts the voltage accordingly. The process is suitable for all materials, shielding gases
and welding positions. 1-MIG supports WiseSteel, WisePenetration+ and WiseFusion features, as
well as various optimized welding programs.
To adjust the welding power / wire feed speed while welding, in the Control Pad's Welding view,
turn the left knob.
To fine tune the voltage while welding, in the Control Pad's Welding view, turn the right knob.
OPERATING MANUAL | EN 139
©
KEMPPI 2017 | 1817