X8 MIG WELDER 2.5 Operation
The MMA and GOUGING modes just have one pre-installed welding program each.
Standard MIG welding processes in MIG X8 Welder
The processes described in this chapter are available when the MIG mode is selected. For more
information on selecting the MIG mode, see Selecting a welding program on page 136.
The easiest way to take a certain process into use is to select a memory channel with a welding
program that uses that process. For more information, see Channel view on page 103.
The list of adjustable welding parameters in Settings > Parameters varies according to the
selected welding program.
MIG
!
MIG is a conventional 2-knob MIG/MAG welding process that enables adjusting the wire feed
speed and voltage independently. MIG does not support the Wise features.
To adjust the wire feed speed, in the Control Pad's Welding view, turn the left knob.
To adjust the voltage, in the Control Pad's Welding view, turn the right knob.
Figure 28: MIG Welding view
OPERATING MANUAL | EN 138
©
KEMPPI 2017 | 1817
To Next Page
Loading...
