X8 MIG WELDER 2.5 Operation
To adjust the dynamics while welding, in the Control Pad's Welding view, turn the right knob.
Figure 39: Gouging Welding view
You can adjust the following parameters through Settings > Parameters:
• Gouging welding program: gouging program selection
• Current: adjusts the gouging current
• Dynamics: adjusts the short circuit behaviour. On the minus side, the arc is softer. On the plus
side, the arc is harder (the arc is more stable).
Cladding and brazing
Cladding
Cladding (surfacing) means depositing a layer of filler material on the workpiece to achieve
certain properties or dimensions.
To use X8 MIG Welder for cladding, in Settings, select the mode (MMA/MIG), and in the filter list,
for Type, select Cladding to see the suitable welding programs.
X8 MIG Welder has a variety of optimized welding programs for cladding.
Brazing
In brazing, only the filler material is melted while the base material stays solid. With X8 MIG
Welder, you can use a variety of welding programs and filler materials for brazing.
OPERATING MANUAL | EN 151
©
KEMPPI 2017 | 1817
To Next Page
Loading...
