Kemppi X8 User Manual

X8 MIG WELDER 2.6 Troubleshooting
Problem Recommended actions
The wire burns into the contact tip
• Make sure the size and type of the current tip and
liner are suitable for the filler wire.
• Make sure the wire liner is clean.
• Make sure the wire liner does not make any steep
loops.
• Check the motor current level. If the current is too
high, there may be problems in the wire liner.
• Check the tightness of the feeding rolls. Too tight
feeding rolls may affect soft filler wires, such as
aluminium and flux-cored wires.
The gun overheats
• Make sure the gun's neck is correctly connected to
the handle: push the neck deep enough and check
that the neck tightener is properly tightened.
• Make sure that the contact tip adapter is properly
hand-tightened and the contact tip properly
attached to it.
• Make sure that the welding parameters are within
the range of the welding gun and the neck.
The gun and the neck have separate limits for
the maximum current; the lower of these is the
maximum current that can be used.
The gun neck overheats
• Make sure you are using original Kemppi
consumable and spare parts. Incorrect spare part
materials may cause the overheating of the neck.
The welding gun connector
overheats
• Make sure the connector is properly connected to
the wire feeder.
• Make sure the current transfer surface and the
connector pins of the gun connector are clean and
undamaged.
The gun vibrates too much during
welding
• Check the tightness of the contact tip adapter and
contact tip.
• Check the motor current.
• Check the wire liner.
• Check the filler wire. It must be straight and start
coiling when it comes out from the contact tip. If
not, check the tightness of the feeding rolls.
OPERATING MANUAL | EN 157
©
KEMPPI 2017 | 1817

Kemppi X8 Specifications

General

Brand	Kemppi
Model	X8
Category	Welding System
Language	English